Replacing the 2.5" HDD backplane
4.6
Replacing the 2.5" HDD backplane
Two 2.5" HDD backplanes are mounted on the HDD cage.
Ê Open the server as described in the
Ê Remove all the hot-plug hard disk drives (for a description see the Operating
Manual).
V
CAUTION!
Check if all hard disk drives are uniquely identified so that you can
reinsert them into their original bays.
Figure 14: Disconnecting cables
Ê Disconnect the connectors of the SAS/SATA cable (1) and the power cable
(2) from the 2.5" HDD backplane.
Ê Remove the two screws (see circles).
36
section "Preparation" on page
Service Supplement
23.
TX200 S6