Fujitsu PRIMERGY TX200 S6 Service Supplement Manual page 47

Figure 26: Position of the screws
Ê Remove the ten screws from the system board.
Ê Lift the system board slightly using the socket of PCI slot 5, thereby you lift
the system board out of the centre rings of the spacer bolts.
Ê Carefully lift the system board out of the housing in a slight angle. Thereby
you pull the connectors out of the connector panel.
Ê Verify the settings on the new system board (for a description see the
Technical Manual of the system board).
Ê Remove the processor(s) from the defective system board and insert this
processor(s) in the new system board (description see the Options Guide).
TX200 S6
Service Supplement
Replacing the system board
47