Replacing The 3.5" Hdd Backplane - Fujitsu PRIMERGY TX200 S6 Service Supplement Manual

Replacing the 3.5" HDD backplane

4.5 Replacing the 3.5" HDD backplane
As spare part the 3.5" HDD backplane is already mounted in the backplane
holder.
Ê Open the server as described in the
Ê Remove all the hot-plug hard disk drives (for a description see the Operating
Manual).
V
CAUTION!
Check if all hard disk drives are uniquely identified so that you can
reinsert them into their original bays.
Figure 12: Disconnecting cables
Ê Disconnect the connectors of the SAS/SATA cable (1) and the power cable
(2) from the 3.5" HDD backplane.
Ê Remove the screw (see circle).
34
section "Preparation" on page
Service Supplement
23.
TX200 S6