Table of Contents
Advertisement
Chapter 4
4–2
Installation
Installing the BSI Card
Installing 3BSI Card in Compact II
1. Check that there is no damage to the card.
2. Using a flat-bladed screwdriver, remove the two screws securing the front cover of the Compact
II system and remove the cover.
3. You will see three empty slots (each with a long and a short connector—see illustration, below).
Select one of these empty slots to install the card.
If a BRI card is installed in the Compact II, the 3BSI card should be installed in a slot to the right of the BRI
card slot. (Note the card priorities at the start of Chapter 2.)
4. Insert the card into the selected slot.
3BSI card
Advertisement
Table of Contents
