Siemens SIMATIC Rack PC 840 Manual page 78

Configuring the SIMATIC Rack PC 840
"Boot Options" Field
The following submenu appears when you select the "Boot Options" field in the
main menu:
Figure 5-4
Quick Boot
Mode
SETUP prompt
POST Errors
Floppy check
Summary
screen
'Enabled' means that the feature is active. 'Disabled' means that the feature is
inactive.
5-8
PhoenixBIOS Setup Utility
Main
Boot Options
QuickBoot Mode: [Enabled]
SETUP prompt: [Enabled]
POST Errors: [Enabled]
[Disabled]
Floppy check:
Summary screen: [Enabled]
Help Select Item
F1
ESC Exit Select Menu
"Boot Options" Submenu
Some hardware tests are skipped to speed up the boot procedure.
The message PRESS <F2> to enter Setup appears at the bottom of the
screen during the system run-up phase.
The boot process is stopped if an error is detected; you must press F1 to
acknowledge. Enter "Disabled" to avoid the necessity of acknowledging
errors, for example, if no keyboard is connected.
The floppy head is stepped inward and then back to its original position
during the system run-up phase. This test is useful because it
reinitializes the drive.
The most important system parameters are displayed when the system
run-up phase completes.
Item Specific Help
Allows the system to
skip certain tests
while booting. This
will decrease the
time needed to boot
the system.
+ / – Change Values F9
Select
Enter Sub-Menu F10
SIMATIC Rack PC 840 Manual
Setup Defaults
Save and Exit
A5E00104826-03