Siemens SIMATIC Rack PC 840 Manual page 149

Exiting SCSI Setup
When you press the
displayed. If you have made changes in the current menu, you will be asked if you
want to save the changes you have made.
S Repeatedly press the
(Configure/View Host Adapter Settings).
S Press the
to exit SCSI Setup.
SCSI Setup Default Settings
SCSI-Bus Interface Definitions
Host Adapter SCSI ID
SCSI Parity Checking
Host Adapter SCSI Termination
Additional Options
Boot device Options
Boot Target ID
Boot LUN Number*
SCSI Device Configuration (for each SCSI device)
SCSI Device ID
Initiate Sync Negotiation
Maximum Sync Transfer Rate
Enable Disconnection
Initiate Wide Negotiation
Send Start Unit Command**
Multiple LUN Support**
Include in BIOS Scan
Advanced Configuration Options
Plug and Play SCAM Support
Reset SCSI Bus at IC Initialization
Extended BIOS Translation for DOS Drives > 1 Gbyte**
Host Adapter BIOS
Support Removable Disk Under BIOS as Fixed Disks**
Display
BIOS Support for Bootable CD-ROM**
BIOS Support for Int 13 Extensions**
* The setting is only effective if Multiple LUN Support is active (Enabled).
** The setting is only effective if the BIOS of the SCSI controller is active
(Enabled).
SIMATIC Rack PC 840 Manual
A5E00104826-03
key, the previous menu from the current menu level is
ESC
key until you have reached the first menu level
ESC
key in the first menu and follow subsequent screen prompts
ESC
Ctrl A
+ message During BIOS Initialization**
Controller
Default Setting
7
Enabled
LowON/HighON
Default Setting
0
0
1 to 15
Yes
40 Mbyte/s
Yes
Yes
No
No
Yes
Disabled
Enabled
Enabled
Enabled
Boot only
Enabled
Enabled
Enabled
8-5