Replacing A Hot-Swap System Fan - IBM IntelliStation POWER 9114 Model 275 Manual To The Installation

Replacing a Hot-Swap System Fan

To replace a hot-swap system fan, do the following:
1. Pull up on the orange locking knob on the replacement fan to ensure that it is in the unlocked position.
2. Align the fan with the slot in the fan tray assembly with the fan power plug over the connector.
3. Place the fan into the fan tray.
4. Press down on the fan to ensure that the power plug is connected.
Note: The fan starts to run when the power plug connects.
5. Press the locking knob down until you feel it lock into place.
6. Replace the service access cover as described in "Replacing the Service Access Cover" on page 9.
7. Return the system to the operating position as described in "Placing the Model 275 into the Service
and Operating Position" on page 6.
24
IntelliStation POWER 9114 Model 275 Parts Guide