Bezels; Removing The Front Bezel; Replacing The Front Bezel - IBM IntelliStation POWER 9114 Model 275 Manual To The Installation

Bezels

The following procedures describe the removal and replacement of the system bezel. Before performing
the following procedures, read "Safety Notices" on page v.

Removing the Front Bezel

To remove the front bezel, do the following:
1. Remove the bezel door as described in "Bezel Door" on page 10.
2. Press down on the two bezel-release levers.
3. Pull the top of the bezel out and away from the system.
4. Gently pull the bezel up and off the base, releasing the lower bezel locking tabs.
1 Model 275
2 Bezel-Release Levers
3 Front Bezel
4 Front Door

Replacing the Front Bezel

To replace the front bezel, do the following:
1. Place the two lower bezel locking tabs into the retaining slots located on the system base.
2. Rotate the bezel up toward the top of the system, ensuring that the aligning pins are aligned with their
mating holes located on the system.
3. Gently push the bezel in until the two bezel release levers are seated in their respective slots.
4. Replace the bezel door as described in "Bezel Door" on page 10.
1
2
6
5
Chapter 2. Removal, Replacement, and Installation Procedures
3
4
5 Bezel Door Handle
6 Lower Bezel Locking Tab (Quantity 2)
7 Lower Bezel Retaining Slots (Quantity 2)
11