Operator Panel Power Cable; Removing The Operator Panel Power Cable - IBM IntelliStation POWER 9114 Model 275 Manual To The Installation

Operator Panel Power Cable

The following procedures describe the removal and replacement of the operator panel power cable. Before
performing the following procedures, read the "Safety Notices" on page v.

Removing the Operator Panel Power Cable

To remove the operator panel power cable, do the following:
1. Stop the system as described in "Stopping the System" on page 8.
2. Disconnect the power source from the system.
Note: This system may be equipped with a second power supply. Before continuing with this
procedure, ensure that the power source to the system has been completely disconnected.
3. Place the system into the service position as described in "Placing the Model 275 into the Service and
Operating Position" on page 6.
4. Remove the front bezel as described in "Removing the Front Bezel" on page 11.
5. Remove the media bay chassis as described in "Removing the Media Bay Chassis" on page 38.
6. Locate the operator panel, as shown in the following illustrations.
7. Remove the operator panel by pressing the locking tabs located on either side of the panel, grasping
the edges of the panel, and pulling it out of its bay.
8. Disconnect the operator panel power cable from the rear of the operator panel.
1 System Unit

2 Operator Panel Power Cable

3 Operator Panel
4 Operator Panel Locking Tab (2)
40
IntelliStation POWER 9114 Model 275 Parts Guide
5
6
5 Media Bay Chassis (Shown With
SCSI Media Drive Installed)
6 Media Bay Chassis Locking Tab (2)
7 Front Bezel
8 Media Bay Chassis Guide Rail