IBM IntelliStation POWER 9114 Model 275 Manual To The Installation page 59

7. Plug the second power cable into the rear of the new power supply.
Note: Do not connect the power cable to the power source until you are instructed to do so.
8. Connect the power source to the system.
9. Note the state of the LEDs on the top of the power supply. If the LEDs indicate the power supply is
operating normally, continue to the next step. If not, remove the power supply from the system and
repeat the procedure starting with step 5 on page 46. If, after repeating the procedure, the power
supply in not operating normally, contact your service representative.
10. Replace the service access cover as described in "Replacing the Service Access Cover" on page 9.
11. Return the system to the operating position as described in "Placing the Model 275 into the Service
and Operating Position" on page 6.
Chapter 2. Removal, Replacement, and Installation Procedures
47