Requirements
Requirements
Before using this machine you must make sure that all the environmental and
electrical requirements have been met. Connect the machine to your host com-
puter using the parallel port, optional Network Interface Board 450-E (NIB 450-
E), or both.
Make sure that all the cables, connectors, and electrical outlets necessary to at-
tach the machine to your host computer or network are present.
Reference
For further information on using the parallel port. ⇒ P.5 "Connecting the Ma-
chine"
For information on using a network. ⇒ P.5 "Connecting the Machine"
Parallel Cable Requirements
Connect the machine to your host computer using a parallel port. This machine
does not provide the parallel cable to connect the machine to the host computer.
The machine's parallel connection is a standard bi-directional interface. It re-
quires a standard 36-pin parallel cable compliant with IEEE 1284 and a parallel
port available on the host computer.
Note
Do not use a parallel cable more than 3 meters (10 feet) long.
Network Connections
Optional Network Interface Board 450-E (NIB 450-E) can be installed to allow di-
rect connection to an Ethernet network.
The Ethernet card supports 10BaseT or 100BaseTX connections.
You can use the machine in a network environment as follows.
• Using the appropriate network management software and printer driver.
• Attaching the machine to a networked computer set up as a server.
1. Setting up
3