Samson TROVIS 3730-3 Mounting And Operating Instructions page 127

Menu
Set point deviation
Temperature inside device 9.9
Fixed value
(communication)
Fixed value
(communication)
Fixed value over binary
input
Fixed value over binary
input
Diagnosis/maintenance
Device state
Status messages
Condensed state
Start-up
Configuration
Process data
Diagnostics
Total valve travel
Total valve travel limit x
1000
Lag time for set point
deviation
Tolerance band for set
point deviation +/-
Max. temperature inside
device
1)
Min. temperature inside
device
1)
Operating hours counter
The displayed value is merely intended as information. No error message is displayed with the am-
1)
bient temperature exceeds or falls below the permissible range (see section 3.7 on page 27).
EB 8484-3 EN
Adjustment range/values [default setting]/description
9.8 Reading in %
Reading in °C
9.10 Reading in %
9.11 Active/Not active
9.12 Reading in %
9.13 Active/Not active
10
10.1
10.1.1
10.1.1.1
10.1.1.2
10.1.1.29
Messages which may be displayed:
see section 12.3.4
10.1.1.35
10.1.1.40
10.1.2 Totaled full valve travel cycle
10.1.3 Limit of total valve travel limit
10.1.4 Reading in s. The lag time can only be set using the
operator software.
10.1.5 Used for error monitoring.
10.1.6 Reading in °C
10.1.7 Reading in °C
10.1.8 Reading in d:hh:mm:ss
Appendix
127