Configure The Cdm-570/As For 1:1 Redundancy; Figure 4-1. Cdm-570/A Configuration Interface Examples - Comtech EF Data CRS-180 Installation And Operation Manual

CRS-180 70/140 MHz IF 1:1 Redundancy Switch
Modem and Switch Configuration
4.4

Configure the CDM-570/As for 1:1 Redundancy

•
CDM-570/CDM-570L/CDMR-570L Satellite Modem Installation and Operation
Manual (CEFD P/N MN/CDM570L.IOM)
•
CDM-570A/CDM-570AL/CDMR-570AL Satellite Modem Installation and
Operation Manual (CEFD P/N MN-CDM570A)
For correct operation of the CRS-180, the CDM-570/A Satellite Modems must have the
following installed:
• CDM-570A Base Modem Firmware Version 1.1.1 (or higher)
•
CDM-570AL with Optional IP Packet Processor Firmware Version 1.2.1 (or higher)
•
CDM-570 Base Modem Firmware Version 1.6.7 (or higher)
•
CDM-570 IP Module Firmware Version 1.5.4.2 (or higher)
• CDM-570 Hardware Revision 3
•
This manual also presumes that the CDM-570/A has been factory-configured for
50Ω Rx and Tx operation.
If your modems do not meet this requirement, contact Comtech EF Data Product
Support. You may download free Firmware updates from the Comtech EF Data web
site. Hardware revision upgrades must be performed at Comtech EF Data.
Telnet Command Line Interface (CLI)
Ethernet HTTP (Web Server) Interface

Figure 4-1. CDM-570/A Configuration Interface Examples

Front Panel
4–9
MN/CRS180.IOM
Revision 11