Speaker - HP EliteDesk 705 G5 Maintenance And Service Manual

Speaker

The speaker is attached to the inside-front of the computer.
Before removing the speaker, follow these steps:
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
4. Remove the drive cage
Remove the speaker:
1. Remove the two Phillips screws (1) that secure the speaker to the front of the chassis.
2. Disconnect the speaker cable from the system board connector labeled SPKR (2), remove the cable from
the clip (3), and then remove the speaker from the computer (4).
To install the speaker, reverse the removal procedures.
54 Chapter 4 Removal and replacement procedures
(Preparation for disassembly on page
(Access panel on page
(Front bezel on page 24).
(Drive cage on page 26).
23).
20).