Option Card - HP EliteDesk 705 G5 Maintenance And Service Manual

Option card

For a list of available option cards, see
An option card can be installed under the heat sink near the back of the system board that provides an
additional connector on the rear I/O panel.
Before removing the option card, follow these steps:
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the fan duct
Remove the option card:
1. Remove the two Phillips screws (1) that secure the card to the system board.
2. Lift to disengage the card from the system board connector, and then remove the option card from the
computer (2).
To install the option card, reverse the removal procedures.
Computer major components on page
(Preparation for disassembly on page
(Access panel on page
(Fan duct on page 45).
6.
23).
20).
Option card 51