Zone Expansion Module Installation; Battery Installation - Toro EVOLUTION Series User Manual

Zone Expansion Module Installation

TM
The EVOLUTION controller can be expanded using the optional 4-zone (EMOD-4) or 12-zone (EMOD-12) modules to add more
zones to the system.
Figure 9
Step 1
– Open the EVOLUTION
Step 2
– Locate the module slot
tab towards the cabinet until a positive click is achieved. The click indicates that the module's retaining tab is fully engaged.
Once installed, the EVOLUTION
scheduling.
Note: If installing only one four-station module (EMOD-4), it must be installed in the zone 5-8 module slot.
Step 1
– Open the EVOLUTION
internal componenents.
Step 2
– Hold the module as shown in
pulling the module away from the cabinet.

Battery Installation

TM
The EVOLUTION controller uses a 9-VDC battery to retain schedule parameters during
an extended period of power outages.
Step 1
– Open the EVOLUTION
internal components.
Step 2
– Locate the battery compartment at the back of the control panel.
Step 3
– Align the polarity (– and +) of the battery then slide it into the battery
compartment as shown in
TM
controller door and control panel to access the internal components.
and . Install the module by placing the bottom hooked standoffs into slot
A B
TM
controller will be able to read the additional zones and will make them available for
TM
controller door and control panel to access the
. Press the retaining tab while
TM
controller door and control panel to access the
.
Figure 10
B
A
Figure 11
Figure 12
B
A
and push the module
A
– +
7