Zone Expansion Module Installation - Toro EVOLUTION Series Quick Start Manual

220 VAC (Outside US and Canada) Outdoor Models
Step 1 – Route power and ground wires from a power source through a conduit and into the
EVOLUTION cabinet.
®
Step 2 – Open the EVOLUTION
Step 3 – Remove the power compartment cover to access the transformer terminals.
Step 4 – Remove 1/2" (12.7mm) of insulation from the power source wire ends and install the brown wire
into the Line (L)terminal. Install the green wire into the Ground (
into the Neutral (N) terminal.
Step 5 – Install and secure the power compartment cover.
Step 6 – Apply power to the controller.

Zone Expansion Module Installation

The EVOLUTION controller can be expanded using the optional 4-zone (EMOD-4) or
®
12-zone (EMOD-12) modules to add more zones to the system.
Module Installation
Step 1 – Open the EVOLUTION
components.
Step 2 – Locate the module slot
standoffs into slot
achieved. The click indicates that the module's retaining tab is fully engaged.
Once installed, the EVOLUTION
make them available for scheduling.
Note: If installing only one four-station module (EMOD-4), it must be installed in the
zone 5 8 module slot.
Module Removal
Step 1 – Open the EVOLUTION
components.
Step 2 – Hold the module as shown in Figure 11. Press the retaining tab while pulling the top of the
module away from the cabinet, then lift the module out of
the controller.
10
controller and access the internal components.
®
controller door and control panel to access the internal
®
and . Install the module by placing the bottom hooked
A B
and push the module tab towards the cabinet until a positive click is
A
controller will be able to read the additional zones and will
®
controller door and control panel to access the internal
®
) terminal and the blue wire
Figure 9
Figure 10
Figure 11
Figure 8
(L) ( )
Brown
Green/Yellow
220 VAC Outdoor Models
(N)
Blue
B
A
B
A