Firmware; Firmware Update; Factory Reset - Toro EVOLUTION Series User Manual

Firmware

The Firmware function allows you to review the controller's firmware version. Press SELECT
FIRMWARE
CONTROLLER 01.09

Firmware Update

TM
The EVOLUTION controller's firmware can easily be updated by downloading the latest software from www.toro.com/evolution. A USB
flash drive is needed for this procedure.
Step 1
– Create a folder inside your USB flash drive with the name Evolution.
Step 2
– Create a folder inside the Evolution folder with the name Firmware.
Step 3
– Go to the EVOLUTION
firmware inside the Firmware folder in your USB flash drive.
Step 4
– Turn Off the power to the controller.
Step 5
– Press the Up
BOOT LOAD MODE V1.02
USB DRIVE PLEASE !
Step 6
– Connect your USB flash drive into the EVOLUTION
Step 7
– Follow the controller prompts to finalize the firmware update.
Note: Although many USB flash drives may function well with the EVOLUTION
specifications are recommended:
USB Version 2.0 Compliant
1–8 GB Memory Size (Smaller memory size will perform faster.)
FAT32 File System with 1 Logical Partition

Factory Reset

Select this function to reset the controller to the factory default parameters. Schedule B, C and Auxiliary will be disabled and all of their
parameters will be cleared or set to OFF. Schedule A will be set with a WEEKDAY schedule with all 7 days active. It will have one start time
set to OFF and all zone runtimes set to OFF.
FACTORY RESET
RESET TO FACTORY
DEFAULTS? YES
TM
website, www.toro.com/evolution, and download the most current firmware version. Save the
and Down arrows simultaneously and turn On the power to the controller.
Figure 14
TM
USB port.
USB
to access the firmware version.
TM
controller, the following USB
21