Related Manuals for Clarke air CAT49
Summary of Contents for Clarke air CAT49
- Page 1 LONG BED SANDER MODEL NO: CAT49 PART NO: 3110535 OPERATING & MAINTENANCE INSTRUCTIONS GC0714...
-
Page 2: Specification
70 x 400 mm Please note that the details and specifications contained herein are correct at the time of going to print. However Clarke International reserve the right to change specifications at any time without prior notice Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com... -
Page 3: General Safety Rules
GENERAL SAFETY RULES CAUTION: FAILURE TO FOLLOW THESE PRECAUTIONS COULD RESULT IN PERSONAL INJURY, AND/OR DAMAGE TO PROPERTY. WORK ENVIRONMENT 1. Keep the work area clean and tidy. 2. Dress appropriately - Do not wear loose clothing or jewellery. Tie long hair out of the way. -
Page 4: Sander-Specific Safety Rules
• Moving to another work area. • Passing the tool to another person. 13. Never use the tool if it is defective or operating abnormally. 14. This tool should be serviced at regular intervals by qualified personnel. 15. Avoid damaging the tool by applying excessive force of any kind. 16. -
Page 5: Compressed Air Requirements
• A typical air line layout is shown above. If an automatic in-line filter/ regulator is used, it will keep the tool in good condition, but should be regularly checked and topped up with oil. clarke airline oil should be used, and the lubricator adjusted to approx 2 drops per minute. -
Page 6: Before Use
ARE FAMILIAR WITH ALL PRECAUTIONS RELATING TO THE USE OF AIR COMPRESSORS AND COMPRESSED AIR SUPPLY. 1. Pour 2-3 drops of CLARKE airline oil into the air inlet. This should be done regardless of whether or not a lubricated air supply is to be used. -
Page 7: Disconnecting The Air Supply
1. Before use, drain water from the airline filter and compressor. 2. Pour a few drops of Clarke air-line oil, into the tool air inlet. This should be carried out regardless of whether or not an in-line mini oiler is used. If an in- line mini oiler is not used, this procedure should be repeated after every two to three hours of use. - Page 8 If the tool is to be stored, or is idle for longer than 24 hours, run a few drops of Clarke air line oil into the air inlet, and run the tool for 5 seconds in order to lubricate the internal parts.
-
Page 9: Troubleshooting
TROUBLESHOOTING SYMPTOM PROBLEM SOLUTION Tool runs at normal 1. Motor parts worn. 1. Return to Clarke dealer speed but slows down for repair. under any load. 2. Worn or sticking 2. Drip air tool lubricating mechanism due to oil into air inlet. Allow oil lack of lubricant. -
Page 10: Parts Diagram
PARTS DIAGRAM Part No Description No Part No Description 561601 Hose Adaptor 561619 Actuator Gear 561602 Rear Head 561620 Front Head 561603 Packing 561621 Socket cap Screw 561604 Valve 561622 Knob Assembly 561605 O-Ring 561623 Adj. Shaft 561606 O-Ring 561624 Plunger 561607 Socket Screw... -
Page 11: Declaration Of Conformity
Part No Description No Part No Description 561611 Body Assembly 561629 Flat Head Screw 561612 Piston Ring 561630 SideStrip 561613 Piston 561631 Cross head Screw 561614 Wear Button 561632 Carrier Assembly 561633 Cross head Screw 561616-1 Shaft (9.5mm) 561634 Pad Assembly 561617 Gear 561635...