Avaya Vantage Installing And Administering page 144

Supported configuration parameters
Parameter
PHONE_LOCK_ID
LETIME
PHONE_LOCK_PA
SSWORD_FAILED
_ATTEMPTS
LOCK_SCREEN_L
OCK_AFTER_TIM
EOUT
May 2018
Type Default Is set to
value default
on reset
Numeric 60 No
Numeric 8 Yes
Numeric 5 Yes
Installing and Administering Avaya Vantage
Comments on this document? infodev@avaya.com
Description
For provisioning, use:
• The SET command in the
46xxsettings.txtfile.
• The Settings menu on the device.
Specifies the maximum idle time interval in minutes
after which Avaya Vantage
™
Avaya Vantage uses this parameter to determine
the number of options it shows to the user in the
Settings > Security > Lock screen message
menu. By default, this menu has the following
options: 1, 2, 5, 10, 30 minutes, 1 hour, 2 hours, 5
hours, 10 hours, 1 day, 2 days, and 1 week. The
minimum value is 1 minute. The maximum value is
determined as the minimum value between the
PHONE_LOCK_IDLETIME value and the value
specified by the Exchange policy.
For example, if the PHONE_LOCK_IDLETIME
value is 145 and the value specified by the
Exchange policy is 123 minutes, then the Lock
screen message menu will contain values from 1
minute to 2 hours inclusively.
™
Avaya Vantage ignores this parameter if
ENABLE_PHONE_LOCK is 0.
The range is from 1 to 10080.
This parameter is not supported in the non Avaya
™
Breeze CSDK application based mode.
For provisioning, use the SET command in the
46xxsettings.txt file.
Specifies the number of failed attempts to log in
™
before Avaya Vantage becomes locked.
The range is from 8 to 20. If the parameter set to 0,
then the number of failed attempts is unlimited.
This parameter is not supported in the non Avaya
™
Breeze CSDK application based mode.
For provisioning, use the SET command in the
46xxsettings.txt file.
Specifies the Lock screen inactivity timeout in
minutes. The range is from 1 to 10080.
™
™
becomes locked.
Table continues...
144