Avaya Vantage Installing And Administering page 104

Supported configuration parameters
Parameter
NETWORK_MODE Numeric
IPV6STAT
BLUETOOTHSTAT
BLUETOOTH_FEA
TURES_SHARED_
VIA_STAT
May 2018
Type Default Is set to
value default
on reset
1 Yes
Numeric 1
Integer 1 Yes
Integer 0 Yes
Installing and Administering Avaya Vantage
Comments on this document? infodev@avaya.com
Description
• The SET command in the 46xxsettings.txt
file.
Specifies the active network interface. The available
options are:
• 1: Wired Ethernet connection is active.
• 2: Wi-Fi connection is active.
This parameter is supported in all modes.
For provisioning, use the Settings > Network >
Network mode menu on the device.
Controls whether Avaya Vantage
incoming and outgoing IPv6 traffic.
™
• 0: Avaya Vantage blocks IPv6 traffic.
™
• 1: Avaya Vantage does not block IPv6 traffic.
Important:
You must set this parameter to 0 because
™
Avaya Vantage does not support IPv6.
This parameter is applicable for both wired Ethernet
and wireless connections.
This parameter is supported in all modes.
For provisioning, use the SET command in the
46xxsettings.txt file.
Specifies whether Bluetooth is allowed for user
configuration. Assign one of the following values:
• 0: Bluetooth and the Bluetooth menu are
disabled in Settings on the device. The user
cannot enable Bluetooth.
• 1: Bluetooth and the Bleutooth menu are enabled
in Settings on the device. The user can enable or
disable Bluetooth.
This parameter is supported in all modes.
For provisioning, use the SET command in the
46xxsettings.txt file.
Specifies whether users have access to Shared via
Bluetooth options in the Setting menu on the
device.
• 0: Users cannot use Shared via Bluetooth.
™
™
blocks all
Table continues...
104