Avaya Vantage Installing And Administering page 110

Supported configuration parameters
Parameter
PHY2TAGS
PHY2VLAN
VLANSEP
May 2018
Type Default Is set to
value default
on reset
Numeric 0
Numeric 0
Numeric 1
Installing and Administering Avaya Vantage
Comments on this document? infodev@avaya.com
Description
For provisioning, use:
• A name=value pair in a DHCPACK message.
• The SET command in the 46xxsettings.txt
file.
• The Settings > Network > Ethernet > VLAN >
VLAN test timer menu on the device.
Controls whether VLAN tags are stripped from
frames forwarded to the secondary Ethernet
interface.
Assign one of the following values:
• 0: VLAN tags are removed from frames forwarded
to the secondary Ethernet interface.
1: VLAN tags are not removed from frames
forwarded to the secondary Ethernet interface.
For provisioning, use the SET command in the
46xxsettings.txt file.
Specifies the value of the 802.1Q VLAN identifier
that is used to identify tagged frames through the
secondary Ethernet interface.
Valid values are 0 through 4094.
For provisioning, use:
• The SET command in the 46xxsettings.txt
file. The precedence is 3.
• LLDP. The precedence is 4.
Specifies whether the VLAN separation is enabled
or disabled.
Assign one of the following values:
• 0: Disabled.
• 1: Enabled.
For provisioning, use the SET command in the
46xxsettings.txt file.
™
110