Table of Contents
Advertisement
Troubleshooting Tips
If you are having trouble programming Home-
Link®, here are some of the most common
solutions:
Replace the battery in the garage door
opener hand-held transmitter.
Push the LEARN button on the garage door
opener to complete the training for a rolling
code.
Did you unplug the device for programming
and remember to plug it back in?
If you have any problems, or require assis-
tance, please call toll-free 1-800-355-3515 or,
on the Internet at
HomeLink.com
tion or assistance.
WARNING!
Vehicle
exhaust
contains
monoxide, a dangerous gas. Do not run
your vehicle in the garage while program-
ming the transceiver. Exhaust gas can
cause serious injury or death.
WARNING! (Continued)
Your motorized door or gate will open and
close while you are programming the
universal transceiver. Do not program the
transceiver if people, pets or other objects
are in the path of the door or gate. Only
use this transceiver with a garage door
opener that has a "stop and reverse"
feature as required by Federal safety stan-
dards. This includes most garage door
opener models manufactured after 1982.
Do not use a garage door opener without
these safety features.
General Information
for informa-
The following regulatory statement applies to
all Radio Frequency (RF) devices equipped in
this vehicle:
carbon
This device complies with Part 15 of the FCC
Rules and with Innovation, Science and
Economic
license-exempt RSS standard(s). Operation is
subject to the following two conditions:
(Continued)
1. This device may not cause harmful inter-
ference, and
2. This device must accept any interference
received, including interference that may
cause undesired operation.
Le présent appareil est conforme aux CNR
d`Innovation, Science and Economic Develop-
ment applicables aux appareils radio exempts
Development
Canada
de licence. L'exploitation est autorisée aux
deux conditions suivantes:
1. l'appareil ne doit pas produire de brouil-
lage, et
2. l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le
brouillage est susceptible d'en comprom-
ettre le fonctionnement.
La operación de este equipo está sujeta a las
siguientes dos condiciones:
1. es posible que este equipo o dispositivo no
cause interferencia perjudicial y
2. este equipo o dispositivo debe aceptar
cualquier interferencia, incluyendo la que
pueda causar su operación no deseada.
RF Exposure Requirements
To comply with FCC RF exposure compliance
requirements, the device must be installed
and operated to provide a separation distance
of at least 20 cm from all persons.
This equipment complies with Canada radiation
exposure limits set forth for an uncontrolled
environment. This equipment should be
installed and operated with minimum distance
20 cm between the radiator and your body.
NOTE:
Changes or modifications not expressly
approved by the party responsible for compli-
ance could void the user's authority to operate
the equipment.
61
Advertisement
Table of Contents
