Using Homelink; Security; Troubleshooting Tips - Alfa Romeo Giulia 2019 User Manual

Table of Contents

Advertisement

NOTE:
If
the
indicator
light
constantly, programming is complete
and the garage door/device should
activate when the HomeLink® button
is pressed.
To program the two remaining Home-
Link® buttons, repeat each step for
each remaining button. DO NOT erase
the channels.
If you unplugged the garage door opener/
device for programming, plug it back in at
this time.
Reprogramming A Single HomeLink® Button
(Canadian/Gate Operator)
To reprogram a channel that has been previ-
ously trained, follow these steps:
1. Place the ignition to the ON position.
2. Press and hold the desired HomeLink®
button until the indicator light begins to
flash after 20 seconds. Do not release
the button.
3. Without releasing the button, proceed
with "Canadian/Gate Operator Program-
ming" step 2 and follow all remaining
steps.
Using HomeLink®
stays
on
To
operate,
push
programmed HomeLink® button. Activation
will now occur for the programmed device
(i.e. garage door opener, gate operator, secu-
rity system, entry door lock, home/office
lighting, etc.). The hand-held transmitter of
the device may also be used at any time.

Security

It is advised to erase all channels before you
sell or turn in your vehicle.
To do this, push and hold the two outside
buttons for 20 seconds until the orange indi-
cator flashes. Note that all channels will be
erased. Individual channels cannot be
erased.
The HomeLink® Universal Transceiver is
disabled when the Vehicle Security Alarm is
active.
NOTE:
The universal garage door opener only oper-
ates when the engine is running for security
reasons associated with removable tops and
doors.

Troubleshooting Tips

and
release
the
If you are having trouble programming
HomeLink®, here are some of the most
common solutions:
Replace the battery in the garage door
opener hand-held transmitter.
Push the LEARN button on the garage
door opener to complete the training for a
Rolling Code.
Did you unplug the device for program-
ming and remember to plug it back in?
If you have any problems, or require assis-
tance, please call toll-free 1-800-355-3515
or, on the Internet at
information or assistance.
Vehicle
monoxide, a dangerous gas. Do not run
your vehicle in the garage while program-
ming the transceiver. Exhaust gas can
cause serious injury or death.
HomeLink.com
for
WARNING!
exhaust
contains
carbon
(Continued)
41

Advertisement

Table of Contents
loading

Table of Contents