Table of Contents
Advertisement
If you have any problems, or require
additional assistance, please call toll-
free 1-800-355-3515 or visit
HomeLink.com.
NOTE:
If the programming was successful, your garage
door should open and close with your chosen
HomeLink® button.
Use this QR code to access your
digital experience.
TROUBLESHOOTING TIPS
If you are having trouble programming
HomeLink®, here are some of the most common
solutions:
•
Replace the battery in the garage door opener
hand-held transmitter.
•
Push the LEARN button on the garage door
opener to complete the training for a rolling
code.
•
Did you unplug the device for programming
and remember to plug it back in?
If you have any problems, or require additional
assistance, please call toll-free 1-800-355-3515 or
visit HomeLink.com.
32
INTERIOR
WARNING!
•
Vehicle exhaust contains carbon monoxide, a
dangerous gas. Do not run your vehicle in the
garage while programming the transmitter.
Exhaust gas can cause serious injury or death.
•
Your motorized door or gate will open and
close while you are programming the univer-
sal transmitter. Do not program the transmit-
ter if people, pets or other objects are in the
path of the door or gate. Only use this trans-
mitter with a garage door opener that has a
"stop and reverse" feature as required by Fed-
eral safety standards. This includes most
Scan me
garage door opener models manufactured
after 1982. Do not use a garage door opener
without these safety features.
PARKING ASSISTANCE
PARKSENSE FRONT/REAR
PARK ASSIST SYSTEM
Did you know you can enable and disable the
ParkSense system using the ParkSense switch,
located in front of the center console, to the rear
of the gear selector?
ParkSense Switch
WARNING!
•
Drivers must be careful when backing up even
when using ParkSense. Always check carefully
behind your vehicle, look behind you, and be
sure to check for pedestrians, animals, other
vehicles, obstructions, and blind spots before
backing up. You are responsible for safety and
must continue to pay attention to your sur-
roundings. Failure to do so can result in seri-
ous injury or death.
•
Before using ParkSense, it is strongly recom-
mended that the ball mount and hitch ball
assembly be disconnected from the vehicle
when the vehicle is not used for towing. Fail-
ure to do so can result in injury or damage to
vehicles or obstacles because the hitch ball
will be much closer to the obstacle than the
rear fascia/bumper when the vehicle sounds
(Continued)
Advertisement
Table of Contents
