Security; Troubleshooting Tips; Exterior Lights; Headlight Switch - Alfa Romeo Giulia 2024 Owner's Manual

Reprogramming A Single HomeLink® Button
(Canadian/Gate Operator)
To reprogram a channel that has been previously
trained, follow these steps:
1. Place the ignition in the ON/RUN position.
2. Press and hold the desired HomeLink® button until
the indicator light begins to flash after 20 seconds.
Do not release the button.
3. Without releasing the button, proceed with
"Canadian/Gate Operator Programming" Step 2 and
follow all remaining steps.
S
ECURITY
It is advised to erase all channels before you sell or turn
in your vehicle.
To do this, push and hold the two outside buttons for
20 seconds until the indicator flashes. Note that all
channels will be erased. Individual channels cannot be
erased.
The HomeLink® universal transmitter is disabled when
the Vehicle Security system is active.
T T
ROUBLESHOOTING IPS
If you are having trouble programming HomeLink®,
here are some of the most common solutions:
□
Replace the battery in the garage door opener
hand-held transmitter.
□
Push the LEARN button on the garage door opener
to complete the training for a rolling code.
□
Did you unplug the device for programming and
remember to plug it back in?
If you have any problems, or require assistance, please
call toll-free 1-800-355-3515 or visit HomeLink.com for
information or assistance.
46
WARNING!
□
Vehicle exhaust contains carbon monoxide, a
dangerous gas. Do not run your vehicle in the
garage while programming the transmitter.
Exhaust gas can cause serious injury or death.
□
Your motorized door or gate will open and close
while you are programming the universal
transmitter. Do not program the transmitter if
people, pets or other objects are in the path of the
door or gate. Only use this transmitter with a
garage door opener that has a "stop and reverse"
feature as required by Federal safety standards.
This includes most garage door opener models
manufactured after 1982. Do not use a garage
door opener without these safety features.

EXTERIOR LIGHTS

H S
EADLIGHT WITCH
The headlight switch is located on the left side of the
instrument panel, next to the steering wheel. The
headlight switch controls the operation of the
headlights, parking lights, instrument panel lights,
instrument panel light dimming, interior lights and rear
fog lights.
In addition, there are buttons for the ParkSense system
and Engine Stop/Start page 85.

Headlight Switch

1 — ParkSense Button
2 — Parking Lights, Daylight Running Lights, Headlight
Switch
3 — Instrument Panel Dimmer
4 — Rear Fog Light Button
5 — Engine Stop/Start Button
The instrument panel and the various controls on the
dashboard will be illuminated when the exterior lights
are turned on.
To turn on the headlights, rotate the headlight switch
clockwise. When the headlight switch is on, the parking
lights, taillights, license plate light and instrument panel
lights are also turned on. To turn off the headlights,
rotate the headlight switch back to the O (off) position.