Table of Contents
Advertisement
Activation/Deactivation
The TSR System can be activated/deactivated
in the radio system by selecting "Comfort" in
the "Driver Assistance" menu. The system acti-
vation is signaled by road signs shown on the
instrument cluster display.
NOTE:
By selecting "Blinking", the driver can acti-
vate a warning to display when the speed
exceeds the limit indicated by the TSR
System. The speed road sign on the instru-
ment cluster display will blink until the
vehicle speed drops below the displayed
limit.
Selecting "Offset" will set the speed at
which "Blinking" is activated up to a
maximum of 6 mph (10 km/h) above the
limit detected by the system.
If no speed limit signs are found, the system
will revert o the speed limit signs that are
stored in the NAV system.
Indications On The Display
The system status can always be viewed
through the instrument cluster display.
The instrument cluster display shows only the
speed limit indications and consists of the
following steps:
The new speed limit recognized by the
system, which is indicated by means of a
predetermined color. The road sign indi-
cating the end of the speed limit or a "Road
Sign Not Detected" message may appear in
this zone.
After a predetermined distance, the previ-
ously displayed road sign changes color to
inform the driver that the speed limit
provided may no longer be valid.
1 — Traffic Sign Recognized
WARNING!
To prevent serious injury or death:
Always remain alert and be ready to take
control of the vehicle in the event that the
TJA system disables.
Always keep your hands on the steering
wheel when the TJA system is activated.
Maintain a safe distance from other vehi-
cles and pay attention to traffic condi-
tions.
CAUTION!
Functionality may be limited or the system
may not work if the sensor is obstructed.
The system may have limited operation or
not work at all in weather conditions such
as heavy rain, hail, thick fog, and low
temperatures. Strong light contrasts can
influence the recognition capability of the
sensor.
The area surrounding the sensor must not
be covered with stickers or any other
object.
Do not tamper or perform any operations
in the area of the windshield glass directly
surrounding the sensor.
Clean foreign matters such as bird drop-
pings, insects, snow or ice on the wind-
shield. Use specific detergents and clean
cloths to avoid scratching the windshield.
179
Advertisement
Table of Contents
