Using A Pluggable Transceiver (Scp/Stp) - Siemens SIMATIC SFP Series Operating Instructions Manual

Assembling

4.4 Using a pluggable transceiver (SCP/STP)

4.4 Using a pluggable transceiver (SCP/STP)
Figure 4-2
Follow the steps below to insert a pluggable transceiver:
1. Remove the sealing plug of the pluggable transceiver.
2. Hold the pluggable transceiver so that the slight protrusion is on the right, see figure.
3. Insert the pluggable transceiver in this position in the pluggable transceiver slot until you
hear it engage.
The pluggable transceiver is then firmly secured.
4. Insert the connecting cable into the pluggable transceiver until you hear it engage.
The connecting cable is then firmly secured.
20
Plugging in a transceiver
Transceiver SFP/SFP+/SCP/STP
Operating Instructions, 12/2017, A5E02630804-11