Technical data
7.1
SFP transceiver
LC connector technology
The attachment to Industrial Ethernet uses LC connector
technology (Lucent Connector).
7.1.1
SFP991-1/SFP991-1(C)
Properties
Transmission mode
Transmission rate
Transmission medium
Light source
Wavelength
Cable length (max.) *
Transmitter output (optical)
Receiver input
*) Depending on the cable used:
● If you are using at least OM1 fibers (attenuation ≤ 1.5 dB/km, bandwidth length product ≥
500 MHz*km), you can reach a cable length of up to 3 km.
● When are using fibers with attenuation values ≤ 1 dB/km, you can reach a cable length of
up to 5 km.
You can find additional information in the "Industrial Ethernet / PROFINET Passive network
components" System Manual, see also section "Introduction", paragraph "Additional
documentation".
Transceiver SFP/SFP+/SCP/STP
Operating Instructions, 12/2017, A5E02630804-11
100Base-FX complying with IEEE 802.3
100 Mbps (Fast Ethernet)
Multimode fiber-optic cable
LED/Class1-LASER "Eye safe"
1300 nm
At 50 µm fiber core diameter
)
At 62.5 µm fiber core diameter
Minimum
Maximum
Sensitivity min.
Input power max.
Pluggable transceiver slot/
plugged in transceiver
3 km
3 km
At 50 μm
-23 dBm
At 62.5 μm
-19 dBm
-14 dBm
-32 dBm
-3 dBm
7
25