Inserting An Scp / Stp Transceiver - Siemens SIMATIC NET SFP Series Operating Instructions Manual

4.4

Inserting an SCP / STP transceiver

Figure 4-2
Follow the steps below to insert an SCP / STP transceiver:
1. Remove the sealing plug of the SCP / STP transceiver.
2. Hold the SCP / STP transceiver so that the slight protrusion is on the right, see figure.
3. Insert the SCP / STP transceiver in the SCP / STP slot in this position until you hear it
engage, see figure.
The SCP / STP transceiver is then firmly secured.
4. Insert the connecting cable into the SCP / STP transceiver until you hear it engage.
The connecting cable is then firmly secured.
Transceiver SFP/SFP+/SCP/STP
Operating Instructions, 11/2015, A5E02630804-08
Inserting an SCP / STP transceiver
4.4 Inserting an SCP / STP transceiver
Assembling
19