Using A Pluggable Transceiver (Sfp/Sfp+); Notes On Installation Of Scp / Stp Transceivers - Siemens SIMATIC SFP Series Operating Instructions Manual

Assembling

4.3 Notes on installation of SCP / STP transceivers

4.2

Using a pluggable transceiver (SFP/SFP+)

Figure 4-1
Follow the steps below to insert a pluggable transceiver:
1. Remove the sealing plug of the pluggable transceiver.
2. Close the clip of the pluggable transceiver.
3. Insert the pluggable transceiver in the pluggable transceiver slot until you hear it engage,
see figure.
The pluggable transceiver is then firmly secured.
4. Insert the connecting cable into the pluggable transceiver until you hear it engage.
The connecting cable is then firmly secured.
4.3 Notes on installation of SCP / STP transceivers
General notes on pluggable transceivers
NOTICE
Use only approved pluggable transceivers
If you use components not approved by Siemens AG, in particular SCP / STP transceivers,
Siemens cannot accept any responsibility for the correct functioning of the "Ethernet switch
system" according to the specification.
If components are used that have not been Siemens approved, Siemens cannot vouch for
their compatibility or for risk-free use of these components.
Note
Shipbuilding approval
The shipbuilding approval applies to all SCP / STP transceivers.
18
Plugging in a transceiver
Transceiver SFP/SFP+/SCP/STP
Operating Instructions, 12/2017, A5E02630804-11