Jam Code List; Access Procedure - Ricoh FW830 Service Manual

JAM CODE LIST

4. JAM CODE LIST
When a document (original) jam or paper jam occurs, the cause of the jam is
displayed by using the following jam code.

4.1 ACCESS PROCEDURE

1. When a document jam or paper jam occurs, press and hold down the
Clear/Stop key.
2. Read the jam code (DJ001, PJ021, etc.)
NOTE: DJ = Document Jam, PJ = Paper Jam
4.2 DOCUMENT (ORIGINAL) JAM CODE
Code
(DJ =)
00 No jam
01 Initial jam
02 An original is in the machine when the Call
Service indicator turns on.
16 2nd original transport sensor ON check
17 2nd original transport sensor leading edge OFF
check
18 Original registration sensor ON check
19 Original registration sensor leading edge OFF
check
20 Original is not fed within 6 seconds after the
leading edge of the original is detected by original
set sensor. (When the original is fed from the
front original table.)
21 Original is not fed within 6 seconds after the
leading edge of the original is detected by original
entrance sensor. (When the original is fed from
the rear original table.)
Cause of Jam
4-44
31 December 1992
SP Mode No
(Original Misfeed Counter)
—
SP48 (Others)
SP43
(Upper transport section)
SP45
(Lower transport section)
SP43
(Upper transport section)
SP46
(Rear transport section)