Jam Code List; Access Procedure; Jam Code Table - Ricoh FW870 User Manual

JAM CODE LIST

4. JAM CODE LIST
When a document (original) jam or paper jam occurs, the cause of the jam is
displayed by using the following jam code.

4.1 ACCESS PROCEDURE

1. When a document jam or paper jam occurs, press and hold the
Clear/Stop key.
2. Read the jam code.

4.2 JAM CODE TABLE

Jam
Code
dJ01 Initial Jam (Original Set Sensor)
dJ02 Initial Jam (Original Leading Edge Sensor)
dJ03 Initial Jam (Original Registration Sensor)
dJ04 Initial Jam (Original Exit Sensor)
dJ05 Initial Jam (Original Repeat Sensor)
dJ06 Initial Jam (Rear Entrance Sensor)
PJ07 Initial Jam at Power ON (Paper Entrance Sensor)
PJ08 Initial Jam (Paper Registration Sensor)
PJ09 Initial Jam (Fusing Exit Sensor)
PJ10 Initial Jam (Roll Leading Edge Sensor)
dJ15 Displayed after the Emergence Stop key is pressed.
dJ20 The original set sensor and the rear original set sensor are ON at the same time.
The original leading edge sensor does not turn on within 10 seconds after the
dJ21
original transport motor starts rotation.
dJ22 Original is pulled out after the original registration sensor is turned on.
dJ23 Original is too long.
The rear original set sensor turns on after the original is inserted from the front
dJ24 side. (The original set sensor turns on after the original is inserted from the rear
side.)
When the original transportation is reversed, the original exit sensor 3 keeps on
dJ25
for more than 1 second.
The set sensor or the rear original set sensor is activated before the Set Original
dJ26
indicator turns on.
Original registration sensor OFF check at original leading edge (when the original
dJ30
is forwarded)
Original registration sensor ON check at original leading edge (when the original
dJ31
is forwarded)
Original exit sensor OFF check at original leading edge (when the original is
dJ32
forwarded)
Original exit sensor ON check at original leading edge (when the original is
dJ33
forwarded)
Jam Detection Condition
4-44
25 July 1996