How To Access The Sd Card Slot On Main Control Board; How To Upgrade The Panel Firmware From A Sd Card - Honeywell GENT Nano panel-based Commissioning Instructions

How to access the SD card slot on Main Control Board

The SD card slot is located on the Main Control card inside the panel enclosure.
SD card

How to upgrade the panel firmware from a SD card

The panel firmware can be upgraded from a SD card, assuming the SD card holds the firmware you want to load onto the panel. You will need to be at access level 4 to perform the upgrade.
Menu
Engineering
Select
Ensure the SD card is fitted into the Main Controller Board.
DO NOT remove the SD card while the RED
LED is flashing.
4188-949 issue 3_05/10_Nano Comms inst.
A VIEW OF THE ELECTRONIC MODULE
Maintenance >
Select SD Card
Select
Main Control board
RED LED
SD card
You will need to remove the battery
located on the right hand side in the
enclosure to gain access to the
SD card slot.
WARNING
Removal of
cover exposes
live parts
DANGER
To insert the SD Card: Push the card into the slot and release to lock the card.
To remove the SD Card: Push the SD card into the slot and release,
then withdraw the card from the slot.
Select Upgrade
16:15 Wed 10/10/10
Loader V1.xx (xx/xx/09)
Warning! Selecting this option will
S D
prepare the panel for firmware upgrade
L o a d i n g NanoEN
** ALL FUNCTIONS WILL BE DISABLED! ! **
E r s a i n g
** PANEL MUST NOT BE POWERED DOWN! ! **
Yes
11
ARE YOU SURE YOU WANT TO PROCEED ?
Yes No
[amber LED]
To remove the '
Enter 'Customer mode' PIN Code (Access level 2)
Reset
The 'Disablement'
Nano panel based system
C a r d d e t e c t e d
0 1 2 3 4 5 6 7 8 9 10
12 13 14
System Fault Disablement
[amber LED]
System Fault ' indication you will need to press the ' Reset ' button.
indication is automatically removed after the loop has started.
67