Siemens SIMATIC HMI TP 170A Equipment Manual page 76

System Messages
Number
80024 The function Copy_Archive is configured not
to permit copying when the target archive
already contains data (Parameter: Write
mode ).
The archive is not copied.
80025 The copy action is interrupted.
Data written up to this point is retained.
Deletion of the target table (if configured) is
not executed.
The cancellation is documented by an error
entry $RT_ERR$ at the end of the target
table.
110000 The operating mode status has been
changed. The operating mode is now offline .
110001 The operating mode status has been
changed. The operating mode is now online .
110002 The operating mode status has not been
changed.
110003 The operating status of the PLC specified is
changed by the function
PLC_Connect_Isolate .
The operating mode is now offline .
110004 The operating status of the PLC specified is
changed by the function
PLC_Connect_Isolate .
The operating mode is now online .
110005 An attempt was made to use the function
PLC_Connect_Isolate to switch the specified
PLC to operating mode online although the
entire system is in operating mode offline .
This switch-over is not permissible.
The PLC remains in operating mode offline .
120000 The trend is not displayed because an
incorrect axis to the trend, or incorrect trend,
has been configured.
120001 The trend is not displayed because an
incorrect axis to the trend, or incorrect trend,
has been configured.
120002 The trend is not displayed because the tag
assigned tries to access an invalid PLC
address.
130000 The action was not executed.
130001 The action was not executed.
C-6
CuuDuongThanCong.com
Effect/Cause Remedy
Modify the function Copy_Archive in the
project, if necessary.
Before initiating the function, delete the target
archive.
–
–
–
Check the connection to the PLCs.
Check whether the address area for the area
pointer "Coordination" in the PLC is
available.
–
–
Switch the complete system to operating
mode online and execute the function again.
Change the configuration.
Change the configuration.
Check whether the data area for the tag
exists in the PLC, the configured address is
correct or the value range for the tag is
correct.
Close other applications.
Delete files no longer required from the hard
disk.
Delete files no longer required from the hard
disk.
TP 170A Equipment Manual
https://fb.com/tailieudientucntt
Release 12/99