Table of Contents
Advertisement
Installation in front panels
Step
1
Working from the front, insert the operating unit in the mounting cut-out provided.
Make sure the unit cannot drop out of the front panel before it has been secured.
2
Insert the hooks of the screw-type clamps enclosed in the corresponding
recesses in the housing of the operating unit.
The individual positions are indicated in the figure by means of arrows.
3
Use a screwdriver to tighten the operating unit from the rear in the front panel.
Note
Make sure the seal is seated correctly against the front panel.
Never apply torques greater than 0.5 Nm in order to prevent damage.
TP 170A Equipment Manual
Release 12/99
CuuDuongThanCong.com
Action
Front panel
Operating unit
https://fb.com/tailieudientucntt
Installation
7-3
Hide quick links:
Advertisement
Chapters
Table of Contents
