Siemens SINUMERIK 840 Planning Manual page 72

01.91
ZW Status word
Data word for internal statuses in the DB status word (DBZW).
GST Initial setting
F-NR Error No.
In the case of an error, i.e."F" = 1, the cause of the error appears in DR 246 of
DB 150.
Possible parameter assignments
Parameter assignments of the search area
Search area parameters
MAGA
MAGE PLAA
> 0
>=MAGA
= 0
> 0
> 0
= 0
= 0
(1) The search direction "Forwards" can be selected via the "SURI=V" block parameter
assignments. If the parameter is not assigned, i.e. "SURI = ' ' ", the search direction
"Forwards" is also defined internally.
(2) With the parameter assignments, "MAGA" > 0 and "MAGE" = 0, all chained magazines
are searched, starting at "MAGA". The search is not completed until
– the required free magazine area has been found,
– the searched magazine is not assigned to any further, chained magazine,
– the chained magazine corresponds to the magazine specified in the parameter
"MAGA".
Note that all magazines included in the search key must have the same
machine data setting (without configuration) if the search for an empty
location extends over several magazines.
© Siemens AG 1991 All Rights Reserved
SINUMERIK 840/880 (PJ)
5.3 FB 112 Search for empty location without presetting
Specified search area
PLAE Magazine
>=PLAA
MAGA-MAGE
?
>=PLAA
(2)
?
6FC5 197-0AA40-1BP1
5 Configuration
Spec. search
direction
from/to V R
PLAA-PLAE (1) X
1-ENDE (1) X
PLAA-PLAE (1) X
1-ENDE (1) X
5–11