Special Tools; Special Tools - Toro GREENSMASTER 3100 Service Manual

Special Tools

NOTE: Order special tools from the TO R O S P E C IA L
TO O L S A N D A P P LIC AT IO N S G U ID E (C O M M E R C IA L
P R O D U C T S ). Some tools may be listed in the
Greensmaster 3100 Parts Catalog. Some tools may
also be available from a local supplier.
Hydraulic Tester (Fig. 6)
You must have o-ring face seal (ORFS) adapter fittings
for this tester to use it on the Greensmaster 3100.
1. INLET HOSE: Hose connected from the system
circuit to the inlet side of the hydraulic tester.
2. LOAD VALVE: If required, upon turning the valve to
restrict flow, a simulated working load is created in the
circuit.
3. LOW PRESSURE GAUGE: Low range gauge to
provide accurate reading at low pressure, 0 - 1000 psi
(0 - 6895 kPa).
This gauge has a protector valve which cuts out
when pressure is about to exceed the normal range
for the gauge. The cutout pressure is adjustable.
®
Greensmaster 3100
Low Pressure
Gauge
Gauge
Protector Valve
Inlet Hose
Figure 6
4. HIGH PRESSURE GAUGE: High range gauge to
accommodate pressure beyond the capacity of the low
pressure gauge, 0 - 5000 (0 - 34475 kPa).
5. FLOW METER: This meter measures actual oil flow
in the operation circuit. The reading is given in gallons
per minute (GPM) and liters per minute (LPM) with a
gauge rated at 15 GPM (57 LPM).
6. OUTLET HOSE: Hose from the outlet side of the
hydraulic tester to be connected to the hydraulic system
circuit.
Page 4 - 13
Load Valve
Flow Meter
High Pressure
Gauge
Outlet
Hose

Special Tools