Adjustments; Adjustments; Lift And Mow Pedal Height Adjustment - Toro GREENSMASTER 3100 Service Manual

Adjustments

Lift and Mow Pedal Height Adjustment (Fig. 13)
Adjust the lift and mow pedal to equal height to gain
proper spool travel in the valve bank as follows:
1. Put 1, 2 and 3 spools in neutral (center of travel) and
remove transfer rod guard from foot panel.
2. Loosen jam nut securing yoke on front of long control
rod, remove cotter pin and clevis pin.
3. Move adjustment lever by hand to level the mow and
lift pedals and adjust yoke on control rod until hole in
yoke lines up with the adjustment lever hole.
4. Install the clevis pin and cotter pin. tighten the jam nut
and install the transfer rod guard.
5. Actuate the mow pedal by hand. Be sure the lift pivot
under the pedals clears the stop welded to the frame,
thereby allowing full spool travel.

Adjustments

4
Page 4 - 36
2
1
3
Figure 13
1. Jam nut
2. Yoke
3. Control rod
4. Adjustment lever
Greensmaster
®
3100