Preparing A Reel For Grinding - Toro GREENSMASTER 3100 Service Manual

Preparing a Reel for Grinding

Note: Check to make sure the reel bearings are in
good condition before grinding a reel.
1. Remove bedbar assembly (see Bedbar Removal
and Installation).
2. Remove parts as necessary to mount cutting unit
into grinder (e.g., front roller, front roller brackets).
Note: The cutting unit must be aligned so the grinding
wheel will travel parallel to the reel shaft. This will result
in the the reel being ground to the desired cylinder
shape.
Note: When grinding, be careful to not overheat the
reel blades. Remove small amounts of material with
each pass of the grinder.
3. After completing the grinding process:
REEL DIAMETER
BLADE
WIDTH
Greensmaster 3100
LAND
D
1
REEL DIAMETER TAPER = D
A. Install parts removed to mount cutting unit into
grinder.
B. Install bedbar assembly (see Bedbar Removal
and Installation).
C. Complete cutting unit set–up and adjustment se-
quence (see Cutting Unit Operator's Manual).
Reel Grinding Specifications
Nominal Reel Diameter
Service Limit -
Reel Diameter
Blade Relief Angle
Relief Angle Range
Blade Land Width
Land Width Range
Service Limit -
Reel Taper
BLADE RELIEF ANGLE
– D
1
Figure 22
Page 10 - 19
Rev. D
5.06 in (128.5 mm)
4.56 in (118.8 mm)
30_
20_ to 40_
0.040 in (1.0 mm)
0.030 to 0.060 in (0.7 to 1.5 mm)
0.040 in (1.0 mm)
D
2
2
Dual Point Adjust Cutting units