Epson ColorWorks C6500Au Technical Reference Manual page 95

Specifying Data of 2D Symbols
See the following descriptions to specify 2D symbol data.
PDF417 / MicroPDF417
• If the number of columns and rows is 0, they are automatically calculated.
• When specifying a number other than 0, specify the numbers so that multiplying the columns by the rows
equals 928 or lower.
QR Code
• According to the data size, the version is automatically changed to the version appropriate to the size.
Micro QR Code
• The size is automatically determined.
MaxiCode
• Specify a special character as described below.
Control character
SHIFT
CODE B
CODE C
FNC1
FNC2
FNC3
FNC4
DataMatrix
• If data immediately after { does not apply to any one of the followings, an error will occur.
Control character
FNC1
'{'
GS1 DataBar Stacked / GS1 DataBar Stacked Omnidirectional
• Do not include the application identifier "01" in the beginning of data.
• You do not need to add a check digit in the data.
• Printing the 2D symbol with a composite symbol is supported. When printing the 2D symbol with a compos-
ite symbol, use "\|" or "|\" to separate the barcode data from the data for the composite symbol. First enter
data for the composite symbol, then enter data for the 2D symbol.
Hexadecimal
0x7B, 0x53
0x7B, 0x42
0x7B, 0x43
0x7B, 0x31
0x7B, 0x32
0x7B, 0x33
0x7B, 0x34
ASCII
{1
{{
Chapter3 Handling
95