Monitor Menu - Asus DN-300-R2 Manual

Link Status [Disconnected]
Displays the Ethernet connection status.
3.4

Monitor menu

The Monitor menu displays the system temperature/power status, and allows you
to change the fan settings.
CPU / MotherBoard Temperature [xxxºC/xxxºF]
The onboard hardware monitor automatically detects and displays the CPU/
motherboard temperatures.
CPU / PSU Fan Speed [xxxx RPM]
The onboard hardware monitor automatically detects and displays the CPU /
PSU fan speeds in rotations per minute (RPM). If the fan is not connected to the
motherboard, the field shows N/A.
CPU Core Voltage, 3.3V Voltage, 5V Voltage, 12V Voltage, VBAT 3.0V
The onboard hardware monitor automatically detects the voltage output through
the onboard voltage regulators.
Sensor configuration
HW info
+3V
+12V
+5V
Vcore
Battery
MB Temperature
CPU Temperature
PECI
PSU FAN Speed
CPU FAN Speed
CPU Fan Speed Low Limit [Ignore]
This item appears only when you enable the CPU Q-Fan Control feature and
allows you to disable or set the CPU fan warning speed. Configuration options:
[Ignore] [200RPM] [300 RPM] [400 RPM] [500 RPM] [600RPM]
PSU Fan Speed Low Limit [400 RPM]
This item appears only when you enable the PSU Fan Q-Fan Control feature and
allows you to disable or set the PSU Fan warning speed. Configuration options:
[Ignore] [200RPM] [300 RPM] [400 RPM] [500 RPM] [600RPM]
BAT Voltage Low Warning [Enabled]
Allows you to set whether to show a warning message when the BAT voltage is
getting low. Configuration options: [Disabled] [Enabled]
3-14
SIO Pin Register
3VCC Bank0, Index03
VIN2 Bank0, Index05
VIN1 Bank0, Index04
CPUVCORE Bank0, Index00
VBAT Bank0, Index08
SYSTIN Bank3, Index0C
CPUTIN Bank3, Index0D
PECI Bank0, Index19
Bank0, Index30[bit
SYSFANIN
15:8], Index31[bit 7:0]
Bank0, Index32[bit
CPUFANIN
15:8], Index33[bit 7:0]
Calculation
3V Voltage = Reading*0.008*2V
12V Voltage = Reading*0.008*12V
5V Voltage = Reading*0.008*5.02V
Vcore = Reading*0.008*2V
Vbat = Reading*0.008*2V
Compared to 80H, when <80H, the
temperature is positive. The value
shown on the UI will be temperature.
Conversion to decimal is the speed
value.
Conversion to decimal is the speed
value.
DN-300-R2