Asus DN-300-R2 Manual page 18

2. Intel ME Jumper (3-pin DIS_ME)
®
This jumper allows you to enable or disable the Intel
jumper to pins 1-2 to enable (default) the Intel
disable it.
DN-300-R2 Intel
NOTE: Disable the Intel
3. Chassis intrusion connector (3-pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch.
Connect one end of the chassis intrusion sensor or switch cable to this
connector. The chassis intrusion sensor or switch sends a high-level signal to
this connector when a chassis component is removed or replaced. The signal
is then generated as a chassis intrusion event.
DN-300-R2 Chassis intrusion connector
4. Clear password jumper (2-pin CLRPWD)
Short the two pins, and press <F2> to enter BIOS at the next boot. The BIOS
password will be removed.
DN-300-R2 Clear password
2-12
DIS_ME
1 2
Disable ME
(Default)
ME jumper
®
ME function before updating it.
®
CHASSIS
CLRPWD
PIN1
ME function. Set this
®
ME function and to pins 2-3 to
®
2 3
Enable ME
PIN1
DN-300-R2