Network Stack Configuration; Nvme Configuration; Hdd/Ssd Smart Information; Intel(R) Ethernet Connection (7) I219-V - Asus DN-300-R2 Manual

USB Single Port Control
This item allows you to enable or disable the individual USB ports.
Refer to the manual for the location of the USB ports.
3.3.9

Network Stack Configuration

Network Stack [Enabled]
This item allows user to disable or enable the UEFI network stack. Configuration
options: [Disabled] [Enabled]
The following two items appear only when you set the previous item to
[Enabled].
Ipv4 PXE Support [Enabled]
This item allows user to disable or enable the Ipv4 PXE Boot support.
Configuration options: [Disabled] [Enabled]
Ipv6 PXE Support [Enabled]
This item allows user to disable or enable the Ipv6 PXE Boot support.
Configuration options: [Disabled] [Enabled]
3.3.10

NVMe Configuration

This menu displays the NVMe controller and drive information of the connected
devices.
3.3.11

HDD/SSD SMART Information

This menu displays the SMART information of the connected devices.
NVM Express devices do not support SMART information.
3.3.12

Intel(R) Ethernet Connection (7) I219-V

This menu allows you to configure the Ethernet settings.
NIC Configuration
Link Speed [Auto Negotiated]
Specifies the port speed for the selected boot device. Configuration options:
[Auto Negotiated] [10 Mbps Half] [10 Mbps Full] [100 Mbps Half] [100 Mbps Full]
Wake On LAN [Enabled]
Allows you to enable or disable the server powered on using an magic
packet. Configuration options: [Disabled] [Enabled]
Blink LEDs
Identify the physical port by blinking the associated LED.
Chapter 3: BIOS setup
3-13