Asus DN-300-R2 Manual page 23

6. Front panel system panel connector (12-1 pin F_PANEL)
This connector supports several chassis-mounted functions.
DN-300-R2 Front panel connector
• System power LED (2-pin Power LED)
This 2-pin connector is for the system power LED. Connect the chassis
power LED cable to this connector. The system power LED lights up when
you turn on the system power, and blinks when the system is in sleep mode.
• Hard disk drive activity LED (2-pin HDD LED)
This 2-pin connector is for the HDD Activity LED. Connect the HDD Activity
LED cable to this connector. The IDE LED lights up or flashes when data is
read from or written to the HDD.
• System warning speaker (4-1 pin Speaker)
This 4-pin connector is for the chassis-mounted system warning speaker.
The speaker allows you to hear system beeps and warnings.
• ATX power button/soft-off button (2-pin Power switch)
This 2-pin connector is for the system power button.
• Reset button (2-pin Reset)
This 2-pin connector is for the chassis-mounted reset button for system
reboot without turning off the system power.
7. Serial ATA 6.0Gb/s connectors (7-pin SATA6G_0/2/3)
These connector connects to Serial ATA 6.0 Gb/s hard disk drives or an
optical drive via Serial ATA 6.0 Gb/s signal cables.
DN-300-R2 Intel
Chapter 2: Motherboard information
F_PANEL
PIN 1
SATA6G_0
GND
RSATA_RXP0
RSATA_RXN0
GND
RSATA_TXN0
RSATA_TXP0
GND
SATA 6 Gb/s connectors
®
SATA6G_2 SATA6G_3
GND GND
RSATA_RXP2 RSATA_RXP3
RSATA_RXN2 RSATA_RXN3
GND GND
RSATA_TXN2 RSATA_TXN3
RSATA_TXP2 RSATA_TXP3
GND GND
2-17