Completing The Installation; Connecting The Cables - IBM xSeries 455 Installation Manual

5. Close the DIMM access door and verify that the memory port power LED is lit.
6. If you have other options to install or remove, do so now.
7. Close the top cover. Go to "Completing the installation".

Completing the installation

Complete the following steps to complete the installation:
1. Close the top cover.
2. Install the server in the rack cabinet. See the Rack Installation Instructions that
3. Connect the cables and power cords. See "Connecting the cables" for more

Connecting the cables

The following illustration shows the locations of the input and output connectors on
your server.
Notes:
1. You must turn off the server before connecting or disconnecting cables from
24
xSeries 455: Installation Guide
retaining clips, remove the DIMM, and then reinsert it.
DIMM slot 1
Note: The memory hot-plug enabled LED flashes to indicate that data is being
mirrored on the replacement DIMMs. Wait until the LED stops flashing
before you hot-replace DIMMs again.
come with your server for detailed information about how to install the server in
a rack cabinet.
Attention:
v Install your server only in a rack cabinet with perforated doors.
v Do not leave open space above or below an installed server in your rack
cabinet. To help prevent damage to server components, always install a filler
panel to cover the open space and to help ensure proper air circulation. See
the documentation that comes with your rack cabinet for more information.
information.
your server.
DIMM slot 15
DIMM slot 14
DIMM slot 28