IBM xSeries 455 Installation Manual page 45

Protective cover
3. Using an RXE Expansion cable, connect one end of the cable to the RXE
Expansion Port A connector on the remote I/O enclosure.
4. Connect the opposite end of the cable to the RXE Expansion Port A connector
on the applicable server.
5. Using an RXE Expansion cable, connect one end of the cable to the RXE
Expansion Port B connector on the remote I/O enclosure.
6. Connect the opposite end of the cable to the RXE Expansion Port A connector
on the applicable server.
Go to "RXE Management cabling" on page 35.
Multi-node configurations
Complete the following steps to connect a remote I/O enclosure to a two-node or
four-node configuration. For information about cabling the RXE Management Port
Chapter 2. Installing options
33