Maintenance - Stamina 35-1052 Owner's Manual

OPERATIONAL INSTRUCTIONS
PEDAL STRAP ADJUSTMENT
If you feel it is more comfortable for your workout, you can change the PEDAL STRAP(35) to the lower
position in the PEDAL CAP(34) as shown in illustration 1 below. Run the PEDAL STRAP(35) through the
opening from the bottom of the PEDAL CAP(34). Pull the PEDAL STRAP(35) to make the Knot secure
against the bottom of the PEDAL CAP(34). Run the PEDAL STRAP(35) through the opening in the PEDAL
CAP(34) on the other side from the top as shown in the illustration 1, then make the end of the PEDAL
STRAP(35) go up to attach onto the upper part of the PEDAL STRAP(35) with the Hook & Loop Pad.
Attach the end of the PEDAL STRAP(35) to different positions with the Hook & Loop Pad to adjust the
length. Refer to illustration 2.
1.
Hook & Loop Pad

MAINTENANCE

The safety and integrity designed into the Stamina® BodyTrac Glider Rowing Machine 1052 can only
be maintained when the Stamina® BodyTrac Glider Rowing Machine 1052 is regularly examined for
damage and wear. Special attention should be given to the following:
1. Pull on the HANDLEBARS(17, 18) and verify that the SHOCK(22) provides tension.
2. Clean the roller tracks in the CENTER BEAM(1) with an absorbent cloth.
3. Verify that all nuts and bolts are present and properly tightened. Replace missing nuts and bolts.
Tighten loose nuts and bolts.
4. Verify that the CAUTION LABEL(67) is in place and easy to read. Call Stamina Products immediately
at 1-800-375-7520 for a replacement CAUTION LABEL(67) if it is missing or damaged.
5. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
6. Worn or damaged components must be replaced immediately or the Stamina® BodyTrac Glider
Rowing Machine 1052 removed from service until repair is made.
7. Only Stamina Products supplied components should be used to maintain/repair the Stamina®
BodyTrac Glider Rowing Machine 1052.
8. Keep your Stamina® BodyTrac Glider Rowing Machine 1052 clean by wiping it off with an
absorbent cloth after use.
End of Pedal Strap
Knot
15
2.
Hook & Loop Pad