Fiat 500X Owner's Handbook Manual page 196

SWITCHING THE SYSTEM
ON/OFF
The system is switched on/off by
pressing the
Turn the button/knob clockwise to
increase the radio volume or
anticlockwise to decrease it.
USB/iPOD SOURCE
The vehicle is equipped with USB port
and AUX socket. Some versions are
equipped with an SD-SDHC reader
able to read/manage cards with SPI
technology.
Some versions are also equipped with
another USB port, located in the front
armrest compartment.
RADIO MODE
After the desired radio station is
selected, the following information is
shown on the display:
At the top: the list of radio stations
stored (preset) is displayed; the station
being listened to is highlighted.
In the middle: the name of the radio
station being listened to and the
buttons to select the previous or the
next radio station are displayed.
At the bottom: display of the following
buttons:
❒ "Browse": list of the radio stations
available;
194
❒ "AM/FM", "AM/DAB", "FM/DAB":
selection of the desired frequency band
(button reconfigurable according to
the band selected: AM, FM or DAB);
(ON/OFF) button/knob.
❒ "Tune" : manual radio station tuning
(not available for DAB radios);
❒ "Info": additional information on the
source being listened to;
❒ "Audio": access to the "Audio
settings" screen.
Audio menu
The following adjustments can be
carried out using the "Audio" menu:
❒ "Equaliser" (where provided);
❒ "Balance/Fader" (left/right and
front/rear sound balance adjustment);
❒ "Speed/Volume" (speed-dependent
automatic volume control);
❒ "Loudness" (where provided);
❒ "Radio Auto-On";
❒ "Radio Off Delay".
To exit the "Audio" menu, press the
MEDIA MODE
With Media mode active, briefly press
the
previous/next track or keep the
forward the track.
/Done button.
/ buttons to play the
buttons pressed to fast rewind/
Track selection
(Browse)
Note: For languages not supported by
the system which feature special
characters (e.g. Greek), the keyboard is
not available. In these cases this
function will be limited.
Bluetooth® SOURCE
Pairing a Bluetooth®
audio device
To pair a Bluetooth® audio device,
proceed as follows:
❒ activate the Bluetooth® function on
the device;
❒ Press the MEDIA button on the front
panel;
❒ if the "Media" source is active, press
the "Source" button;
❒ select the Bluetooth® Media
source;
❒ press the "Add Device" button;
❒ search for Uconnect™ on the Blue-
tooth® audio device (during the pairing
stage a screen is displayed showing the
progress of the operation);
❒ when requested by the audio device,
enter the PIN code shown on the
system display or confirm on the device
/
the PIN displayed;