Fiat 500X Owner's Handbook Manual page 127

❒ finally, refit inspection flap B fig. 107,
completely tightening fixing screws A.
Fog lights
To replace the bulbs proceed as
follows:
❒ steer the vehicle wheels completely
inwards;
❒ undo screws A fig. 107 using the
screwdriver provided and remove
inspection flap B;
❒ identify the fog light bulb;
❒ turn the bulb-bulb holder assembly
anticlockwise and then remove it sliding
it outwards;
❒ disconnect the electrical connector;
❒ replace the bulb-bulb holder
assembly B fig. 108.
❒ reconnect the electrical connector to
the new bulb-bulb holder assembly,
then fit it ensuring that it locks correctly;
❒ fit the assembly turning it clockwise,
ensuring that it locks correctly;
❒ finally, refit inspection flap B fig. 107,
completely tightening fixing screws A.
Side direction indicators
IMPORTANT The procedure is only
described by way of illustration. It
is advisable to contact a Fiat Dealership
for bulb replacement.
To replace the bulb, proceed as follows:
❒ remove cover B fig. 109 of the door
mirror very carefully (using suitable
equipment in order not to damage the
paintwork) around the frame of the
mirror itself (as shown in the figure);
109
❒ remove lens A, then remove bulb C
pulling it out from its bulb holder.
❒ fit the new bulb, making sure it is
correctly locked;
❒ refit the bulb holder on lens A;
❒ correctly refit the cover B on the door
mirror, making sure it is correctly
locked.
Rear light cluster
To replace the bulbs proceed as
follows:
❒ open the tailgate;
❒ using the provided key
(located in the casing containing the
on-board documents),
undo the two screws A fig. 110, then
release the light cluster from the
relevant pin fastenings, pulling carefully;
110
F1B0149C
111
❒ disconnect the central connector B,
then undo the two screws C;
❒ release the tabs indicated by the
arrows and extract the bulb holder
assembly D fig. 111;
❒ identify the bulb to be replaced (1
Side/Stop - 2 Direction indicator -
3 Rear fog light or Reverse);
F1B0151C
F1B0152C
125